Cool Automation 9000H Installationsanleitung PDF herunterladen (Seite 28)

20 Entek 9000 Series Sensor Installation Guide

Connecting 9000 Series Sensors to Monitors

TYPICAL WIRING FOR IEPE ACCELEROMETER

TO XM-120/121/122 VIBRATION MODULE CHANNEL 2

Shield Ground

Pin A - Signal

Pin B - Common

Cable shield not

connected at this end

Channel 1 Input Signal

Signal Common

Jumping terminals

5 to 6 & 21 to 22

configure the

transducer power

supply for IEPE

tranducer(s)

Channel 2 Input Signal

Note: You may ground the cable shield at either end of the cable. Do not ground the shield

at both ends. Recommended practice is to ground the cable shield at the XM terminal base

and not the sensor.

Note: The internal transducer power supply is providing power to the 9000 sensor.

1 2 ... 23 24 25 26 27 28 29 30

Keine Kommentare

Cool Automation 9000H Installationsanleitung Seite 28