Cool Automation 9000H Installationsanleitung PDF herunterladen (Seite 24)

16 Entek 9000 Series Sensor Installation Guide

Connecting 9000 Series Sensors to Monitors

Common

Channel A Signal

Pin A - Signal

Pin B - Common

Cable shield not

connected at this end

Note: If shield is connected at the transducer, do not

ground the shield at the 5800 monitor end. If shield

connection is unknown at the two pin connector,

ohm out and verify before wiring.

1 SIG AND +24 VDC

3 SIG GND COMMON

6 0-5 VDC RECORDER CHAN A

7 GND

8 4-20 MA CURRENT TRANSMITTER CHAN A

9 -24 VDC

10 ANALYZER CHAN A

1 ANALYZER CHAN B

2 +24 VDC

3 4-20 MA CURRENT TRANSMITTER CHAN B

4 GND

5 0-5 VDC RECORDER CHAN B

8 SIG GND COMMON

10 SIG AND +24 VCD

Pin A - Signal

Pin B - Common

Shield

Common

Channel B Signal

Shield

Cable shield not

connected at this end

CONNECTING 9000 SERIES TRANSDUCERS TO A 5800 MONITOR

This shows a dual-channel card. For single-channel

card, only wire in top channel

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30

Keine Kommentare

Cool Automation 9000H Installationsanleitung Seite 24